Manuals / Brands / Home Audio / CD Player / Yamaha / Home Audio / CD Player

Yamaha CRW2200, CRW2200NB About IDE, Typical IDE-typehardware installation

1 51

Download 51 pages, 1.71 Mb

Setup Procedures

About IDE

IDE (Enhanced IDE/E-IDE) is one of the standards applied to the connection between personal computers and their peripherals. A computer motherboard provides two IDE connectors (primary and secondary). (Although, some motherboards provide only a primary connector.) You may connect up to two IDE devices (hard disk, CD-ROM, or CD-R drives) to the connectors using an IDE cable. One of the devices connected via the IDE cable is called “master” and the other is called “slave.”

Slave

Motherboard

Primary

Master

Secondary

SlaveMaster

Notes

•When you are using the IDE device as a master, connect the device to the connector of the leading edge of the IDE cable, or you are using the device as a slave, connect the device to the connector of the middle of the IDE cable.

•When you connect two IDE devices to one IDE cable, assign each as MASTER or SLAVE respectively. The CRW2200E drive is shipped with the SLAVE setting.

Typical IDE-type hardware installation

When replacing an existing IDE-type drive to another Controller Port, you will need to change the device settings (MASTER/SLAVE).

Note

For details on settings, refer to the documentation that came with the device or the Manufacturer’s Home Page.

14

Contents

Page Page Page Page SAFETY PRECAUTIONS WARNING CAUTION ■About CD-R/RWdiscs 2.All trademarks contained in this manual belong to their respective owners Reproduction of this manual, either in part or in full, is expressly forbidden ■Precautions for Transportation ■Copyrights Table of Contents Introduction Features of the CRW2200E Drive ●Generous 8MB of buffer memory ●Buffer Underrun Protection ●Optimum Write Speed Control Buffer Underrun Defined Yamaha Buffer Underrun Protection CRW2200 Before Use System Requirements Supported Discs About CD-ROMs About Partial CAV (Constant Angular Velocity) Serial Number Front and Rear of Unit Front Panel Rear Panel Setup Procedures Tools Setup Flowchart Connecting the CRW2200E Drive Page Choosing the Connection Method As a supplemental drive As a replacement drive About IDE Typical IDE-typehardware installation Connecting examples Example-1:As secondary slave (For supplemental drive) Example-2:As secondary master (For replacing your existing drive with the unit) Page Setting the Jumper Switches Installing the CRW2200E Drive 6As a supplemental drive Page 8Connect the IDE cable 9Connect the audio cable Connecting the analog audio cable Connecting the digital audio cable Connect a 13Reconnect the computer to the AC outlet and power it up Configuring the Operating System About DMA Settings (Setting of Transfer Mode) About DMA Installing the CD Writing Software 16Install the CD writing software Operation Loading a Disc Ejecting a Disc Ejecting a Disc in an Emergency Troubleshooting The disc tray does not open The disc keeps being ejected The drive does not operate correctly No sound of CD-DA(audio CD) disc is audible 1 The “Properties” setting of the CRW2200E drive 2The setting of the Windows Media Player The “Buffer Underrun” error message is displayed Other problems Appendix Writing Modes Session-at-Once(SAO) Packet Writing About the firmware LED Indicator Messages Supported Formats Page The CRW2200 series complies with the following specifications Index Page EUROPE, EASTERN EUROPE and RUSSIA U.S.A CANADA AUSTRALIA