Yamaha CRW2200, CRW2200NB 24

Setup Procedures

Notes

•When replacing an IDE-type hardware solely to a IDE cable, select master for the drive, and connect it at the end of the cable.

•When the operating system starts with the SCSI hard drive, a primary IDE connector may have no IDE devices. In such a case, Yamaha recommends you connect the CRW2200E drive as a primary master.

•When you connect the removed IDE-type hardware to the other connector of the cable, some cables may have only one connector. In such a case, use the cable with two connectors.

Contents

Page Page Page Page SAFETY PRECAUTIONS WARNING CAUTION ■About CD-R/RWdiscs 2.All trademarks contained in this manual belong to their respective owners Reproduction of this manual, either in part or in full, is expressly forbidden ■Precautions for Transportation ■Copyrights Table of Contents Introduction Features of the CRW2200E Drive ●Generous 8MB of buffer memory ●Buffer Underrun Protection ●Optimum Write Speed Control Buffer Underrun Defined Yamaha Buffer Underrun Protection CRW2200 Before Use System Requirements Supported Discs About CD-ROMs About Partial CAV (Constant Angular Velocity) Serial Number Front and Rear of Unit Front Panel Rear Panel Setup Procedures Tools Setup Flowchart Connecting the CRW2200E Drive Page Choosing the Connection Method As a supplemental drive As a replacement drive About IDE Typical IDE-typehardware installation Connecting examples Example-1:As secondary slave (For supplemental drive) Example-2:As secondary master (For replacing your existing drive with the unit) Page Setting the Jumper Switches Installing the CRW2200E Drive 6As a supplemental drive Page 8Connect the IDE cable 9Connect the audio cable Connecting the analog audio cable Connecting the digital audio cable Connect a 13Reconnect the computer to the AC outlet and power it up Configuring the Operating System About DMA Settings (Setting of Transfer Mode) About DMA Installing the CD Writing Software 16Install the CD writing software Operation Loading a Disc Ejecting a Disc Ejecting a Disc in an Emergency Troubleshooting The disc tray does not open The disc keeps being ejected The drive does not operate correctly No sound of CD-DA(audio CD) disc is audible 1 The “Properties” setting of the CRW2200E drive 2The setting of the Windows Media Player The “Buffer Underrun” error message is displayed Other problems Appendix Writing Modes Session-at-Once(SAO) Packet Writing About the firmware LED Indicator Messages Supported Formats Page The CRW2200 series complies with the following specifications Index Page EUROPE, EASTERN EUROPE and RUSSIA U.S.A CANADA AUSTRALIA