Manuals / Brands / Home Audio / CD Player / Yamaha / Home Audio / CD Player

Yamaha CRW2200, CRW2200NB CRW2200E, Connecting the digital audio cable

1 51

Download 51 pages, 1.71 Mb

Setup Procedures

Note

Some sound cards may have one or more audio input connectors.

However, depending on your connectors, the specifications may differ from the CRW2200E drive. If no sound is audible from the speaker even though the audio cable is connected, refer to the documentation that came with your sound card for more details, and make sure that your audio cable is connected correctly.

The ANALOG AUDIO OUT connector of the CRW2200E drive is shown in the figure on the previous page.

Connecting the digital audio cable

The digital connection for the CRW2200E drive is ideal for pure quality audio playback, outputting digital signals recorded on CDs to the sound card without any distortion.

Examples of the digital connection

To output digital audio signals to external devices, you must use the digital connection to connect the unit and the sound card. With this connection you can:

•Enjoy music using a digital audio amplifier.

•Record music digitally with an MD player.

Use the digital audio cable to connect the DIGITAL AUDIO OUT connector of the unit and the SPDIF input connector (digital audio) of the sound card, making sure of the connector’s direction.

DIGITAL AUDIO

OUT

Ground (G)

Signal (D)

Digital audio cable

Sound card

SPDIF

Note

For the digital connection, you need a digital audio cable with appropriate connectors, and a sound card with SPDIF (digital audio) input connectors.

The DIGITAL AUDIO OUT connector of the CRW2200E drive is shown in the figure above.

22

Contents

Page Page Page Page SAFETY PRECAUTIONS WARNING CAUTION ■About CD-R/RWdiscs 2.All trademarks contained in this manual belong to their respective owners Reproduction of this manual, either in part or in full, is expressly forbidden ■Precautions for Transportation ■Copyrights Table of Contents Introduction Features of the CRW2200E Drive ●Generous 8MB of buffer memory ●Buffer Underrun Protection ●Optimum Write Speed Control Buffer Underrun Defined Yamaha Buffer Underrun Protection CRW2200 Before Use System Requirements Supported Discs About CD-ROMs About Partial CAV (Constant Angular Velocity) Serial Number Front and Rear of Unit Front Panel Rear Panel Setup Procedures Tools Setup Flowchart Connecting the CRW2200E Drive Page Choosing the Connection Method As a supplemental drive As a replacement drive About IDE Typical IDE-typehardware installation Connecting examples Example-1:As secondary slave (For supplemental drive) Example-2:As secondary master (For replacing your existing drive with the unit) Page Setting the Jumper Switches Installing the CRW2200E Drive 6As a supplemental drive Page 8Connect the IDE cable 9Connect the audio cable Connecting the analog audio cable Connecting the digital audio cable Connect a 13Reconnect the computer to the AC outlet and power it up Configuring the Operating System About DMA Settings (Setting of Transfer Mode) About DMA Installing the CD Writing Software 16Install the CD writing software Operation Loading a Disc Ejecting a Disc Ejecting a Disc in an Emergency Troubleshooting The disc tray does not open The disc keeps being ejected The drive does not operate correctly No sound of CD-DA(audio CD) disc is audible 1 The “Properties” setting of the CRW2200E drive 2The setting of the Windows Media Player The “Buffer Underrun” error message is displayed Other problems Appendix Writing Modes Session-at-Once(SAO) Packet Writing About the firmware LED Indicator Messages Supported Formats Page The CRW2200 series complies with the following specifications Index Page EUROPE, EASTERN EUROPE and RUSSIA U.S.A CANADA AUSTRALIA