Installation

About IDE 2

Yamaha recommends you connect only the CRW8424E as a secondary master.

Example-1

(slave)

 

 

 

(master)

 

 

IDE cable (primary)

 

CD-ROM Drive e.t.c.

 

 

 

Hard Disk

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Drive

 

 

 

 

 

 

Remove the CD-ROM drive e.t.c.

 

 

 

 

 

 

 

 

 

to replace it with the CRW8424E

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

IDE cable (Secondary)

 

 

 

 

 

 

 

 

 

 

 

 

Additional

No Device

 

 

 

CRW8424E

 

 

 

 

 

(slave)

 

 

 

(master)

Connect.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Example-2

(slave)

 

 

 

(master)

 

 

IDE cable (primary)

IDE device

 

 

 

Hard Disk

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

IDE cable (Secondary)

 

 

 

 

 

 

 

 

 

 

 

 

No device

 

 

CD-ROM Drive e.t.c.

 

 

 

 

 

 

 

 

 

 

(slave) Connect.

Remove.

 

 

 

 

 

 

 

 

 

CRW8424E

 

(master)

If you disconnect the IDE device and re-connect it to another location, other devices connected to the IDE cable may become slow in processing, unstable, or inoperative.

If the 40-pin IDE cable has only one connector available but you wish to re-connect the IDE device (that you just disconnected) to another location, use a 40-pin IDE cable that has two connectors.

If you connect only one IDE device to an IDE cable, assign the device as a master and connect it to the end of the cable.

6Remove the four screws holding the CD-ROM drive in place, then slide the drive forward and out of the drive bay.

Before removing the CD-ROM drive from the computer, make sure that all the cables have been removed from the CD-ROM drive’s rear panel.

Do not force pulling or apply excessive force to the CD-ROM drive.

Replacing Drive

13