Yamaha DPX-830 owner manual Inserting the batteries into the remote control, Attach the rear lid

◆Inserting the batteries into the remote control

1	3	1.	Remove the rear lid of the remote control.
		2.	Check the polarity markings (+, –) of the batteries, and set
			them correctly, inserting their (–) side first.
			• If the battery is inserted from the (+) side first, inserting the (–)
			side becomes difficult because the coil spring end hits on the
			battery side. If the battery is forced to insert in this way, the
			outer label of the battery may get ripped and cause a short-
2			circuit and heating.
		3.	Attach the rear lid.

Important

• Use two size-AAA batteries (R03).

• Replace the two batteries with new ones when the remote control is slow to operate.

Caution

•Using the wrong type of battery may cause an explosion.

•Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

•Dispose of used batteries according to your local regulations.

•Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fire.

•Be sure to handle the battery according to the instructions.

•Load the battery with its positive (+) and negative (–) sides correctly oriented as indicated on the remote control.

•Keep batteries out of reach of children and pets.

•Remove the batteries, if the remote control is not used for a long time.

•Do not combine a new battery with an old one.

•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

4