Ground (earth) Lead
Diameter:
0.12mm (0.005 in)/ampere
EX;
10 Ampere → 1.2mm (0.05 in)
| AE00088 |
1 | CONNECTION NOTES |
|
9Avoid connecting the generator to commercial
power outlet.
9 Avoid connecting the generator in parallel with any other generator.
2 | 1 Correct |
2Incorrect
|
| AE00091 | |
|
| CONNECTION | |
1 |
| w |
|
| Before the generator can be connected to a build- | ||
|
| ||
|
| ing’s electrical system, a licensed electrician must | |
|
| install an isolation (transfer) switch in the build- | |
|
| ing’s main fuse box. The switch is the connection | |
2 |
| point for generator power and allows selection of | |
| generator or main line power to the building. This | ||
|
| ||
|
| will prevent the generator from charging the main | |
|
| power line (backfeeding) when the main power | |
|
| supply has failed or has been turned off for line | |
| repair. Backfeeding can electrocute or injure line | ||
|
| maintenance personnel. Also, generator and build- | |
| |||
|
| ing electrical system damage can occur when nor- | |
|
| mal operating power returns if unit is used without | |
|
| an isolation switch. | |
|
|
|
|
AE00086
EXTENSION CORD NOTES
9When using an extension cord, its total length
should not exceed
60 meters for cross section of 1.5 mm square and
100 meters for cross section of 2.5 mm square.
9This extension cord should be protected by a tough flexible rubber sheath (IEC 245) or the equivalent to withstand mechanical stresses.
– 6 –