11
EMX2000—Owner’s Manual
Rear panel
1SPEAKERS (speaker output) jacks
Speakers can be connected to these jacks.
The type of signals output, the number of speak-
ers you can connect, and acceptable impedance
differ depending on the setting of the Power amp
select switch (control panel V).
•When the Power amp select switch is set to ST
L-ST R or MONI 1-MONO:
You can connect one or two speakers to each of
the L and R jacks.
When the Power amp select switch is set to ST L-
ST R, the speakers connected to the L and R jacks
will output the ST L and ST R bus signals. When
the switch is set to MONI 1-MONO, the speakers
will output the MONITOR L signal and the mon-
aural signal respectively.
Whichever way the switch is set to, connect 4~8Ω
speakers if you use one speaker per channel. The
maximum output is 200W+200W with two 4Ω
speakers.
If you wish to use two speakers per channel, use
8~16Ω speakers. The maximum output is
200W+200W with 8Ω impedance.
•When the Power amp select switch is set to
MONO BRIDGE:
If you are connecting a single speaker to the
BRIDGE jack, use a 8~16Ω speaker. The speaker
outputs the MONO bus signal, and the maxi-
mum output is 400W with 8Ω impedance.
If the signal output from the BRIDGE jack is the
signal input to the P.AMP IN jack, be sure to
input the signal to the P.AMP IN L jack.
2POWER switch
This switch turns on/off the power to the
EMX2000.
SPEAKERS
POWER
R
BRIDGE
ON OFF
2121
L
2
1
Caution:
When using a bridge connection, do not con-
nect anything to the SPEAKERS L or SPEAK-
ERS R jacks.
Likewise, when using the SPEAKERS L and/
or SPEAKERS R jacks, do not connect any-
thing to the BRIDGE jack.
Note: Before turning on the power to the
EMX2000, be sure to turn down the LEVEL
control U on the control panel.