18
EMX2000—Owner’s Manual
■Input specifications■Output specifications

Specifications are subject to change without prior notice.

1. Sensitivity is the lowest level that can produce an output of +4 dB (1.23 V) or the nominal output level when the unit is set at maximum gain.
2. XLR type connectors and PHONE JACKS (TRS) (T=HOT, R=COLD, S=GND) are balanced.
3. PHONE JACKS are unbalanced.
•In these specifications when dB represents a specific voltage, 0 dB is referenced to 0.775 Vrms, 0 dBV is referenced to 1 Vrms.
1. PHONE JACKS are balaned.
•In these specifications when dB represents a specific voltage, 0 dB is referenced to 0.775 Vrms, 0 dBV is referenced 1 Vrms.
Input terminals Gain
trim Actual load
impedance For use with
nominal
Input level
Connectors on mixer
Sensitivity1Max. before clip
MIC INPUT
(1–8) MAX
MIN 5 kΩ50~600Ω Mics –60 dB (775 µV)
–16 dB (123 mV) –40 dB (7.75 mV)
+4 dB (1.23 V) XLR-3-31 type2
LINE INPUT
(1–8) MAX
MIN 50 kΩ600Ω Lines –34 dB (15.5 mV)
+10 dB (2.45 V) –14 dB (155 mV)
+30 dB (24.5 V) PHONE JACK (TRS)2
ST INPUT
(9–12) MAX
MIN 10 kΩ600Ω Lines –34 dB (15.5 mV)
+10 dB (2.45 V) –14 dB (155 mV)
+30 dB (24.5 V) PHONE JACK3
ST SUB IN (1, 2) 10 kΩ600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
TAPE IN (L, R) 10 kΩ600Ω Lines –10 dBV (316 mV) +10 dBV (3.16 V) PHONO JACK
CH INSERT IN (1–4) 10 kΩ600Ω Lines 0 dB (775 mV) +20 dB (7.75 V) PHONE JACK (I/O)3
POWER AMP IN (L, R) 10 kΩ600Ω Lines +4 dB (1.23 V) +18 dB (6.16 V) PHONE JACK3
Output terminal Actual source
impedance For use with
nominal
Output level Connectors on
mixer
Nominal Max. before cliping
ST OUT 1, 2 (L/R) 75Ω600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
PHONE JACK1
MONO OUT 75Ω600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
EFFECT SEND 75Ω600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
MONITOR OUT 1, 2 75Ω600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
REC OUT (L/R) 600Ω10 kΩ Lines –10 dBV (316 mV) +10 dBV (3.16 V) PHONO JACK
CH INSERT OUT (1–4) 600Ω10 kΩ Lines 0 dB (775 mV) +20 dB (7.75 V) PHONE JACK1
PHONES/
C. R. OUT
for PHONES 100Ω40Ω Phones 3 mW 100 mW ST PHONE JACK1
for C. R. OUT 10 kΩ Lines +4 dB (1.23 V) +20 dB (7.75 V)
SPEAKER OUT 1, 2 (L/R) 0.1Ω4/8Ω Speaker 200 W/4Ω200 W/4ΩPHONE JACK1
BRIDGE OUT 0.1Ω8Ω Speaker 400 W/8Ω400 W/8Ω