Operation

EMU27820

Stopping engine

Before stopping the engine, first let it cool off for a few minutes at idle or low speed. Stopping the engine immediately after operating at high speed is not recommended.

EMU27844

Procedure

1.Push and hold the engine stop button or turn the main switch to “ ” (off).

2.After stopping the engine, disconnect the fuel line if there is a fuel joint on the outboard motor.

ZMU03632

3.Tighten the air vent screw on the fuel tank cap (if equipped).

ZMU02301

4.Remove the key if the boat will be left unattended.

NOTE:

The engine can also be stopped by pulling the lanyard and removing the lock plate from the engine stop switch, then turning the main switch to “ ” (off).

EMU27861

Trimming outboard motor

The trim angle of the outboard motor helps determine the position of the bow of the boat in the water. Correct trim angle will help improve performance and fuel economy while reducing strain on the engine. Correct trim angle depends upon the combination of boat, engine, and propeller. Correct trim is also affected by variables such as the load in

32