Trouble Recovery

1

3

2

1

2

ZMU05099

1

ZMU03668

1.Manual valve screw

2.Put the engine in the desired position, then tighten the manual valve screw by

turning it clockwise.

EMU29540

Starter will not operate

If the starter mechanism does not operate (the engine cannot be cranked with the start- er), the engine can be started manually with

1.Fuse (20 A ⋅ 3, 30 A ⋅ 1)

2.Spare fuse (20 A ⋅ 3, 30 A ⋅ 1)

3.Fuse puller

EMU29520

Power trim and tilt will not operate

If the engine cannot be tilted up or down with the power trim and tilt/ the power tilt because of a discharged battery or a failure with the power trim and tilt unit/the power tilt, the engine can be tilted manually.

1.Loosen the manual valve screw by turn- ing it counterclockwise until it stops.

an emergency starter rope. However, the engine cannot be started manually if the battery voltage is low. If the battery is discharged to 9 volts or below, the electric fuel pump will not operate.

EWM01020

WARNING

●Use this procedure only in an emergen- cy and only to return to port for repairs.

●When the emergency starter rope is used to start the engine, the start-in- gear protection device does not oper- ate. Make sure the remote control lever is in neutral. Otherwise the boat could unexpectedly start to move, which could result in an accident.

●Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating.

●Do not attach the lanyard to clothing that could tear loose. Do not route the

64