MAINTENANCE
1
2
3
4
5
6
7
8
A
B
Drive Belt
To remove the drive belt:
1.Set the drive select lever halfway between forward and reverse.
2.Pull up on the drive belt and push it outward over the edge of the secondary sheave.
3.Turn the secondary sheave clock- wise and the drive belt will roll off the sheave.
4.Remove the drive belt from the pri- mary sheave.
Inspection:
To inspect the drive belt, check for frayed edges or tears, and measure drive belt against the following specifi- cation. If the belt shows excessive wear or damage, replace the belt with a new one.
åNew: 1.22 in. (31.0 mm)
∫ Replace when belt reaches:
1.06in. (27 mm)
9
10
11
5.To install the drive belt, reverse the above steps, rolling the belt back over the secondary sheave.
UTILITY |