CONNECTIONS
Connecting the antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength.
Connect each antenna correctly to the designated terminals.
AM loop antenna | Indoor FM |
(included) | antenna |
| (included) |
TUNER
AM
ANT
GND
75Ω UNBAL.
FM
ANT
Ground (GND terminal)
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
| |||
1 | 2 |
|
|
| 11 | (7/16) |
|
| 8 | (5/16) | Unit: |
| 6 | (1/14) | mm (inch) |
■Connecting the AM loop antenna
1 Set up the AM loop antenna, then connect it to the terminals on this unit.
2 Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and GND terminals.
3 Orient the AM loop antenna for the best reception.
Notes
•The AM loop antenna should be placed away from this unit.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
PREPARATION
Open the cover of the included
3
Lead wire
Cut the external sleeve of the
A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas.
FREQUENCY STEP switch (China and General models only)
Because the
Cut the lead wire and remove it.
4 |
| 5 |
Clamp | Clamp with |
|
with | pliers. |
|
pliers. |
|
|
| Insert the wire | Snap the cover into |
| into the slot. | place. |
Insert the cable wire into the |
| |
slot, and clamp it with pliers. |
| |
spacing differs in different areas, set the FREQUENCY STEP switch (located on the rear panel) according to the frequency spacing in your area.
North, Central and South America:
100 kHz/10 kHz
Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect the AC power plug of this unit from the AC outlet.
English
13
