Onkyo 29344937 Connecting the AV receiver, Connecting the Speaker Cables, Terminal posts

Connecting the AV receiver—Continued

Connecting the Speaker Cables

Terminal posts

1	Strip 1/2"-5/8" (12-	1/2"-5/8" (12-15 mm)
	15 mm) of insulation
	from the ends of the
	speaker cables. (Supplied
	speaker cables are already
	stripped.)
2	Unscrew the terminal. Fully insert the bare wire,
	making sure that it’s touching the threaded shaft
	in the center. Screw the terminal tight.

Push terminals

1	Strip 3/8"-1/2"	3/8"-1/2" (10-12 mm)
	(10-12 mm) of insulation
	from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.
2	While pressing the lever, insert

the wire into the hole, and then release the lever.

Make sure that the terminals are gripping the bare wires, not the insulation.

The following illustration shows which speaker should be connected to each pair of terminals for up to 7.1-channel playback.

If you’re using only one surround back speaker, connect it to the power amplifier’s left terminals.

		Blue
Surround	Surround	Surround	Surround
back left	back right	left	right
speaker	speaker	speaker	speaker

Brown

Gray

Tan

				Green
	Front high	Front high		Center
	left speaker	right speaker	Front left	speaker
Powered	(Optional)	(Optional)		Front right
			speaker	speaker
Subwoofer
			White	Red

Notes:

•The speakers are configured by using the “Speaker Settings” on page 44 and “Speaker Setup” on page 68.

•When you connect the front high left and right speakers, preparate it sepalately.

20