Onkyo HT-S6200 Using Audyssey 2EQ, First Time Setup—Continued, Notes, Turn on the AV receiver

First Time Setup—Continued

Using Audyssey 2EQ™

Notes:

•(Asian models) If any of your speakers is 4 ohms, change the Speaker Impedance setting before running the Audyssey 2EQ Room Correction and speaker setup (see page 44).

•If the AV receiver is muted, it will be unmuted automatically when the Audyssey 2EQ Room Correction and Speaker Setup starts.

•Room correction and speaker setup cannot be performed while a pair of headphones is connected.

•It takes about 10 minutes to complete the room correction and speaker setup for three positions. Total measurement time varies depending on the number of speakers.

•Do not connect or disconnect any speakers during room correction and speaker setup.

ON/STANDBY

Speaker setup microphone

SETUP MIC

ENTER

1	Turn on the AV receiver.
2	Set the speaker setup
	microphone at the Main Listening
	Position a (page 46), and
	connect it to the SETUP MIC jack.
	Audyssey indicator
	The speaker setting menu appears.
	If you change these settings, refer to
	steps 5–6 on “Speaker Settings”
	(page 44) or step 5 on “Setting the
	Powered Zone 2” (page 81).

Notes:

•Before starting Audyssey 2EQ™ Room Correction and Speaker Setup, arrange the room and connect the speakers as you would for enjoying movies. Changes to the room after auto setup requires you run the auto setup again, as room EQ characteristics may have changed.

•When starting the room correction and speaker setup, do not stand between the speakers and microphone, and avoid obstacles blocking the path between speakers and microphone. This will produce inaccurate results.

•Position the microphone at ear height of a seated listener with the microphone tip pointed directly at the ceiling using a tripod. Do not hold the microphone in your hand during measurements as this will produce innacurate results.

•Make the room as quiet as possible. Background noise can disrupt the room measurements. Close windows, silence cell phones, televisions, radios, air conditioners, fluorescent lights, home appliances, light dimmers, or other devices.

•Cell phones should be turned off or placed away from all audio electronics during the measurement process as Radio Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use).

3	Press [ENTER].
	The room calibration and speaker setup starts.

Test tones are played through each speaker as Audyssey 2EQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measure- ments and do not stand between speakers and the microphone.

Note:

You can cancel the Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.

4	When the following display appears,
	move the speaker setup microphone to
	measurement point b (page 46), and
	then press [ENTER].

Audyssey 2EQ performs more measurements. This takes a few minutes.

47