Onkyo HT-S6200, 29344937 Zone 2—Continued, Setting the Powered Zone, Setup closes, Notes

Zone 2—Continued

Setting the Powered Zone 2	3	Use the Up and Down [q]/[w]
If you’ve connected your Zone 2 speakers to the AV		buttons to select “2-1. Sp

receiver, as explained in “Connecting Your Zone 2

Settings”, and then press [ENTER].

Speakers Directly to the AV receiver” on page 80, you must set the “PwrdZ2” (Powered Zone 2) setting to “Act” (Activated).

RECEIVER

qwer

ENTER

SETUP

1	Press the [RECEIVER] button,
	followed by the [SETUP] button.

2	Use the Up and Down [q]/[w]
	buttons to select “2. Speaker

Setup”, and then press [ENTER].

4	Use the Up and Down [q]/[w]
	buttons to select “PwrdZ2”.

5 Use the Left and Right [e]/[r]

buttons to select:

Not Act: ZONE 2 SPEAKERS L/R speaker terminals not activated (Powered Zone 2 disabled).

Act: ZONE 2 SPEAKERS L/R speaker terminals activated (Powered Zone 2 enabled).

6	Press the [SETUP] button.
	Setup closes.

Notes:

•When “Act” is selected and Zone 2 turned on, the Zone 2 speakers connected to the ZONE 2 SPEAKERS L/R speaker terminals output sound, but the surround back speakers connected to the SURR BACK L/R speaker terminals do not. When “Act” is selected and Zone 2 turned off, the surround back speakers output sound as normal.

•When the “Powered Zone 2” setting is set to “Act” and the input selector of Zone 2 is selected, power con- sumption on standby mode slightly increases.

•“Powered Zone 2” cannot be used if “Sp Type” is set to “Bi-Amp” (page 44).

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

81