Onkyo HT-S6200 Remote controller doesn’t work, Can’t control other components, There’s no sound

Troubleshooting—Continued

•If the message “Resolution Error” appears on the AV receiver’s display, this indicates that your TV does not support the current video resolution and you need to select another resolution on your DVD player.

Tuner

Reception is noisy, stereo FM reception suffers from hiss, or the FM STEREO indicator doesn’t light up

•Relocate your antenna.

•Move the AV receiver away from your TV or computer.

•When listening to an AM station, operating the remote controller may cause noise.

•Passing cars and airplanes can cause interference.

•Concrete walls weaken radio signals.

•If nothing improves the reception, install an outdoor antenna.

Remote Controller

The remote controller doesn’t work

•Make sure that the batteries are installed with the correct polarity (page 16).

•Make sure that the remote controller is not too far away from the AV receiver and there’s no obstruction between the remote controller and the AV receiver’s remote control sensor (page 16).

•Make sure you’ve selected the correct remote controller mode (pages 17 and 86–92).

•Make sure you’ve entered the correct remote control code (page 84).

Can’t control other components

•Make sure you’ve selected the correct remote controller mode (pages 17 and 86–92).

•If you’ve connected an u-capable Onkyo RI Dock to the TV/TAPE IN, CBL/SAT IN or VCR/DVR IN jacks, for the remote controller to work properly, you must set the Input Display to “DOCK” (page 45).

•The entered remote control code may not be correct. If more than one code is listed, try each one.

•With some AV components, certain buttons may not work as expected, and some may not work at all.

•To control an Onkyo component that’s connected via u, point the remote controller at the AV receiver. Be sure to enter the appropriate remote control code first (page 85).

•To control an Onkyo component that’s not connected via u, or another manufacturer’s component, point the remote controller at that component. Be sure to enter the appropriate remote control code first (page 84).

Dock for iPod or iPhone

There’s no sound

•Make sure your iPod or iPhone is playing.

•Make sure your iPod or iPhone is inserted properly in the Dock.

•Make sure the UP-A1 series Dock is connected to the UNIVERSAL PORT jack on the AV receiver.

•Make sure the AV receiver is turned on, the correct input source is selected, and the volume is turned up.

•Make sure the plugs are pushed in all the way.

•Try resetting your iPod or iPhone.

There’s no video

•Make sure that your iPod or iPhone’s TV OUT setting is set to On.

•Make sure the correct input is selected on your TV or the AV receiver.

•Some versions of the iPod or iPhone do not output video.

The AV receiver’s remote controller doesn’t control your iPod or iPhone

•Make sure your iPod or iPhone is properly inserted in the Dock. If your iPod or iPhone is in a case, it may not connect properly to the Dock. Always remove your iPod or iPhone from the case before inserting it into the Dock.

•The iPod or iPhone cannot be operated while it’s displaying the Apple logo.

•Make sure you’ve selected the right remote mode.

•When you use the AV receiver’s remote controller, point it toward your amp.

•If you still can’t control your iPod or iPhone, start playback by pressing your iPod or iPhone’s Play button. Remote operation should then be possible.

•Try resetting your iPod or iPhone.

•Depending on your iPod or iPhone, some buttons may not work as expected.

The AV receiver unexpectedly selects your iPod or iPhone as the input source

•Always pause iPod or iPhone playback before selecting a different input source. If playback is not paused, the Direct Change function may select your iPod or iPhone as the input source by mistake during the transition between tracks.

95