Onkyo HT-S6200 Setting the Display Brightness, Muting the AV receiver, Using the Sleep Timer

Basic Operations—Continued

Setting the Display Brightness

You can adjust the brightness of the display.

Press the [RECEIVER] button,

Remote	and then press the remote
controller
	controller’s [DIMMER] button
	repeatedly to select: dim,
	dimmer, or normal brightness.
	You can also use the AV receiver’s
	[DIMMER] button.
AV receiver

Muting the AV receiver

Using the Sleep Timer

With the sleep timer, you can set the AV receiver so that it turns off automatically after a specified period.

Press the [RECEIVER] button, and then press the remote controller’s [SLEEP] button repeatedly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about 5 seconds, then the previous display reappears.

SLEEP indicator

You can temporarily mute the output of the AV receiver.		To cancel the sleep timer, press the [SLEEP] button
		repeatedly until the SLEEP indicator disappears.
		To check the remaining sleep time, press the [SLEEP]
	Press the [RECEIVER] button,
		button. Note that if you press the [SLEEP] button while
	and then press the remote
		the sleep time is being displayed, you’ll shorten the sleep
	controller’s [MUTING] button.
		time by 10 minutes.
	The output is muted and the MUTING
	indicator flashes on the display.
		Using Headphones
		For private listening, you can connect a pair of stereo
		headphones (1/4-inch phone plug) to the AV receiver’s
		PHONES jack.

To unmute the AV receiver, press the remote controller’s [MUTING] button again, or adjust the volume. The output is unmuted and the MUTING indicator goes off.

Muting is cancelled when the AV receiver is set to Standby.

Notes:

• Always turn down the volume before connecting your headphones.

• While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Powered Zone 2 speakers are not turned off.)

• When you connect a pair of headphones, the listening mode is set to Stereo, unless it was already set to Pure Audio, Mono, Stereo, or Direct, in which case it stays the same. (Pure Audio listening mode is not available for North American models.)

51