![Basic Operations—Continued](/images/new-backgrounds/21798/2179899x1.webp)
Basic Operations—Continued
This section explains functions that can be used with any input source.
| DISPLAY | |
Press |
| |
[RECEIVER] | MUTING | |
first | ||
|
DIMMER | SLEEP |
MUSIC OPTIMIZER DIMMER DISPLAY
PHONES TONE
Adjusting the Bass & Treble
You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio listening mode is selected.
AV receiver Press the [TONE] button repeatedly to select either
“Bass” or “Treble”.
Use the TONE
Tip:
This procedure can also be performed on the remote controller by using [AUDIO] button (see page 73).
■Bass
You can boost or cut
■Treble
You can boost or cut
Displaying Source Information
You can display various information about the current input source as follows.
Press the [RECEIVER] button, and then press the [DISPLAY] button repeatedly to cycle through the available information.
Note:
This procedure can also be performed on the AV receiver by using its [DISPLAY] button.
The following information can typically be displayed:
Input source & volume*1
Signal format*2 or sampling frequency
Input source & listening mode
*1 When AM or FM radio is used, the band, preset number, and frequency are displayed.
*2 If the input signal is analog, or AM or FM radio is selected, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed. Information is displayed for about 3 seconds, then the previous display reappears.
50