Operation
ZMU02030
NOTE:
●When the engine is cold, it needs to be warmed up. For further information, see page 23.
●If the engine does not start on the first try, repeat the procedure. If the engine fails to start after 4 or 5 tries, open the throttle a small amount (between 1/8 and 1/4) and try again. Also if the engine is warm and fails to start, open the throttle a same amount and try to start the engine again. If the engine still fails to start, see page 45.
EMU27670
Warming up engine
EMU27680
Choke start models
1.After starting the engine, allow it to idle for 3 minutes to warm up. Failure to do so will shorten engine life. Gradually re- turn the choke knob to its home position as the engine warms up.
2.Check for a steady flow of water from the
cooling water pilot hole.
ECM00510
CAUTION:
A flow of water from the hole on the exhaust cover shows that the water pump is pumping water through the cooling pas- sages. If water is not flowing out of the hole at all times while the engine is run- ning, overheating and serious damage
could occur. Stop the engine and check whether the cooling water inlet on the lower case or the cooling water pilot hole is blocked. Consult your Yamaha dealer if the problem cannot be located and cor- rected.
ZMU02856
EMU27740
Shifting
EWM00180
WARNING
Before shifting, make sure there are no swimmers or obstacles in the water near you.
ECM00220
CAUTION:
To change the boat direction or shifting position from forward to reverse or vice- versa, first close the throttle so that the engine idles (or runs at low speeds).
EMU27763
Forward (tiller handle and remote control models)
Tiller control models
1.Place the throttle grip in the fully closed position.
23