Yamaha MD 8 - page 85

Using MIDI Clock 77

MD8—Owner’s Manual

5. Use the CURSOR shuttle to select the measure and time signature param-

eters and set the desired values using the DATA dial.

The setting range for the measure parameter is 1–999, while Meter allows for 1–99/2–16 set-

tings. In other words, you could program a 99/16 time signature.

While the measure ﬁeld is ﬂashing, you can also turn the DATA dial to the left to select the

last measure of your Tempo Map and then scroll through your map in reverse order.

6. Press the [ENTER] button.

The A once again ﬂashes on the display.

7. Use the DATA dial to select the next step (B).

8. Use the CURSOR shuttle to select the measure and time signature param-

eters and set the desired values using the DATA dial.

9. Press the [ENTER] button.

The B now ﬂashes on the display. Repeat steps (7) and (8) to program other Meter changes.

10. Press the [ENTER] button again to return to the Utility mode, or press

[EXIT] or [UTILITY] to leave the Utility mode altogether.

Song Tempo

Setting the tempo is similar to setting the time signature. Tempo changes do not have to

occur in the same places as time signature changes, but they are linked to the Meter settings.

See below for details.

1. Press the [EDIT] button and use the DATA dial to select the Song Tempo

function.

2. Press the [ENTER] button.

The display shows Meter Setup.

3. Use the DATA dial to select Tempo Setup and press the [ENTER] button.

The display shows EDIT Tempo.

4. To modify an existing Tempo (time signature) value, press the [ENTER]

button. To reset the Tempo Map, use the DATA dial to select NEW Tempo

and press the [ENTER] button.

The display now shows A 001-1 ®120 . “A” is the name of the currently selected step,

“001-1” refers to the ﬁrst beat of the ﬁrst measure 1, and “120” is the tempo. The value

“000-0” for the remaining steps means that the tempo change occurs before the song actually

starts (in measure 0), which is another way of saying that the step in question is not being

used.

The A ﬂashes.

Note: If you select a measure number that is already assigned to a preceding step, the time

signature value for that step is replaced by the new value. Example: if, after setting

B 002 10/4 , you set C 002 4/4 , step B will use the 4/4 time signature, while step C

is reset to C 000 4/4 .

Note: If you select NEW, all Tempo changes are reset to their default values.

Note: The measure value of step A cannot be changed.