11
English
Names and Functions
F
COAXIAL IN/OUT jacks
These jacks are used to input and output dig-
ital audio signals via digital audio pin cables.
Select either the COAXIAL IN jacks
or OPTICAL IN jacks. (page 33.)
These jacks, along with the OPTICAL
IN/OUT jacks
7
are also called “DIG-
ITAL IN/OUT.”
G
OPTICAL IN/OUT jacks
These jacks are used to input and output dig-
ital audio signals via optical fiber cables.
The OPTICAL connectors are protected
by plastic covers. You must remove the
cover before connecting the cable. Please
remember to replace the cover when you
disconnect the cable.
Select either the COAXIAL IN jacks
or OPTICAL IN jacks. (page 33.)
These jacks, along with the COAXIAL
IN/OUT jacks
6
are also called “DIG-
ITAL IN/OUT.”
H
mLAN (IEEE1394) jacks
These jacks are used to connect mLAN
devices or IEEE1394-compatible devices via
IEEE1394 standard (6-pin) cables. Each jack
has an LED in the upper left corner to indi-
cate the following statuses.
green : The mLAN8P or connected device
is a “leaf” node.
off : Not connected.
red : Sound somewhere other than the
connected device is interrupted
when you remove the cable.
I
RT/ERR LED
This LED indicates the following statuses.
green : The mLAN8P is a “root.”
orange :An error has occurred. (IEEE1394
bus-related)
red : An error has occurred. (Other errors)
off : Status other than above.
* The same LED is located on the top panel.
Refer to “LED/LCD Messages” on
page 37 for information on the error
indication.
J
ACTIVE LED
This LED indicates the following statuses.
blue : The relay function is active.
off : The relay function is disabled.
Since the mLAN8P does not function
as a bus relay when the power is
turned off, the active LED also indi-
cates whether the power to the unit is
on (blue) or off.
NOTE
NOTE
NOTE
NOTE