Yamaha MLAN8P Settings for the MIDI Section

29
English
Mode Functions
[Balance (Output Balance)]
This parameter enables you to set the stereo balance of the stereo audio output signal. The
default value is 0 (Center).
When you raise the L value, the stereo position shifts to left. When you raise the R value, the
stereo position shifts to right. The setting for one channel will also be applied to the other
channel.
Value: L63 - R63
[Level]
This parameter enables you to set the volume level of the stereo output signal.
Value: 0dB - – ∞
dB
Follow the steps below to connect the mLAN device and the MIDI device connected to the MIDI
IN/OUT terminals on the rear panel of the mLAN8P.
1. Press the [MIDI/UTILITY] button.
2. Press the [IN] or [OUT-A/B] button.
3. Use the [ PAGE ] button to select a parameter you wish to set.
4. Use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select the names of the
devices and parameter values.
A
[MIDI/UTILITY] - [IN]
You can route the MIDI signals from the device connected to the MIDI IN terminal on the rear
panel to any channel on the mLAN.
[MIDI In Device/Nickname]
Use the [Device/Nickname] parameter to specify the name of the device you wish to assign as
the destination of the MIDI signals from the device connected to the MIDI IN terminal. If you
are not connecting any devices, select “Unconnected.”
Settings for the MIDI Section