Yamaha MU5 - page 19

15

● Using Batteries

To use the MU5 on battery power, insert six 1.5V AA size

(SUM-3, R-6 or equivalent) manganese or alkaline batteries in

the battery compartment. Make sure to follow the polarity

indications on the bottom case (and as shown below).

Securely replace the battery compartment cover when done

installing the batteries.

Setting Up Your MU5

● When to Replace the Batteries

When the battery power runs too low to operate the MU5, the

following display will appear:

PART PGM VOICE NAME

#

When this happens, replace all batteries with a complete set of six

new batteries of the same type.

CAUTION!

■ In order to avoid losing any important memory

settings when battery power becomes low, turn off

the MU5, then immediately connect a power

adaptor (to supply continuous power) and replace

all batteries.

■ NEVER mix old and new batteries or different

types of batteries! Also, to prevent possible dam-

age due to battery leakage, remove the batteries

from the instrument if it is not to be used for an

extended period of time.

Contents

Main FCC INFORMATION (U.S.A.) CANADA Entsorgung leerer Batterien (nur innerhalb Deutschlands) SPECIAL MESSAGE SECTION (U.S.A.) PLEASE KEEP THIS MANUAL Welcome to the MU5 Table of Contents Page How to Use This Manual Page Precautions REMOVING CONNECTIONS THE INSTRUMENT YOURSELF TONE GENERATOR qwert yuo i The Controls of the MU5 Front Panel q Display w ,. buttons Page Rear Panel Side Panel The MU5 What It Is and What It Can Do What It Is... About General MIDI What It Can Do... When Connected to a Computer or Sequencer About the Modes of the MU5 Setting Up Your MU5 Power Supply Page Audio Connections Setting Up the MU5 in Your Music System Connecting With a Computer Page Page Connecting to Other MIDI Devices Data Flow Block Diagram 22 MIDI/Computer Connecting Cables MIDI Macintosh Apple Macintosh Peripheral cable (M0197). Maximum length 2 meters. Playing the Demo Song Using the MU5 The Play Mode Playing the Keyboard Changing the Octave Setting Selecting a Part and Changing the Voice Using the Number Keys to Select a Voice Using the MU5 with a Computer or Sequencer Using the MU5 with a MIDI Data Storage Device Muting and Soloing Parts Editing Page Reference Utility Mode Master Tune Transpose Mute Lock Velocity Local Control Dump Out All Saving & Restoring Data via MIDI Saving & Restoring Data via TO HOST Page Initialize All Part Edit Mode Volume Pan MIDI Channel Note Shift Part Tune Pitch Bend Range Appendix Troubleshooting Page Error Messages Specifications Index Page Voice List Voice List Voice List Drum Map Voice List Page Page MIDI Data Format 1. General 2. MIDI Reception / Transmission Diagrams 2.2 Receive Condition MIDI Data Format 3. Channel Messages Page Page Page Page 4. System Exclusive Messages Page Page Page Page Page 5. Active Sensing (Status FE) MIDI Parameter Charts Chart 1-2 : MIDI Parameter Change table ( SYSTEM ) * Cannot be used as a start address. Chart 1-3 : MIDI Parameter Change table ( MULTI PART )