Yamaha MU5 - page 41

37

Utility Mode

Operation

1

Make sure that the MU5 is properly connected to the

device and that the HOST SELECT switch is properly set.

When using the MIDI terminals, connect the MIDI OUT of

the MU5 to the MIDI IN of the data recorder. (See the

Saving & Restoring Data via MIDI illustration above.)

Also, set the HOST SELECT switch to MIDI.

When using the TO HOST terminal, make sure that the

HOST SELECT switch is set corresponding to the device to

be used. (Refer to pages 17 – 21 for more on host computer

connections.)

2

Simultaneously hold down the s buttons and press

E.

A “Sending” message appears in the display during the

operation. Once started, the operation cannot be stopped.

When the operation is completed, the MU5 returns to the

normal Play mode.

■ Setting the Device Number

The settings allow you to select the device number speci-

fied for the data dump. If you are using more than one

MU5, set a different device number (1 – 16) for each unit

before sending the data. If you have only one MU5, set this

to ALL.

■ When using the number keys to enter a value for device

number, the value “0” corresponds to “ALL.”

● To reload the data from the data recorder back to the MU5:

Make sure that the devices are properly connected (see the

Saving & Restoring Data via MIDI illustrations above), and

execute the appropriate data transfer operation from the data

recorder. (Refer to the owner’s manual of that device for instruc-

tions.) The MU5 automatically receives incoming bulk data.

Contents

Main FCC INFORMATION (U.S.A.) CANADA Entsorgung leerer Batterien (nur innerhalb Deutschlands) SPECIAL MESSAGE SECTION (U.S.A.) PLEASE KEEP THIS MANUAL Welcome to the MU5 Table of Contents Page How to Use This Manual Page Precautions REMOVING CONNECTIONS THE INSTRUMENT YOURSELF TONE GENERATOR qwert yuo i The Controls of the MU5 Front Panel q Display w ,. buttons Page Rear Panel Side Panel The MU5 What It Is and What It Can Do What It Is... About General MIDI What It Can Do... When Connected to a Computer or Sequencer About the Modes of the MU5 Setting Up Your MU5 Power Supply Page Audio Connections Setting Up the MU5 in Your Music System Connecting With a Computer Page Page Connecting to Other MIDI Devices Data Flow Block Diagram 22 MIDI/Computer Connecting Cables MIDI Macintosh Apple Macintosh Peripheral cable (M0197). Maximum length 2 meters. Playing the Demo Song Using the MU5 The Play Mode Playing the Keyboard Changing the Octave Setting Selecting a Part and Changing the Voice Using the Number Keys to Select a Voice Using the MU5 with a Computer or Sequencer Using the MU5 with a MIDI Data Storage Device Muting and Soloing Parts Editing Page Reference Utility Mode Master Tune Transpose Mute Lock Velocity Local Control Dump Out All Saving & Restoring Data via MIDI Saving & Restoring Data via TO HOST Page Initialize All Part Edit Mode Volume Pan MIDI Channel Note Shift Part Tune Pitch Bend Range Appendix Troubleshooting Page Error Messages Specifications Index Page Voice List Voice List Voice List Drum Map Voice List Page Page MIDI Data Format 1. General 2. MIDI Reception / Transmission Diagrams 2.2 Receive Condition MIDI Data Format 3. Channel Messages Page Page Page Page 4. System Exclusive Messages Page Page Page Page Page 5. Active Sensing (Status FE) MIDI Parameter Charts Chart 1-2 : MIDI Parameter Change table ( SYSTEM ) * Cannot be used as a start address. Chart 1-3 : MIDI Parameter Change table ( MULTI PART )