A Hands-On Guide to the n8/n12
Owner’s Manual 27
English
3.
Adjust the volume level of the input channels to
which your instruments or microphones are
connected by moving the corresponding faders.
On the n12 if you set the Meter section’s [INPUT
METER] switch to POST, you will be able to use the
input meter of each channel to check the post-fader
signal level. If the C-R SOURCE SELECT [ST] switch
in the Control Room section is turned on, you can
monitor the STEREO bus signal in the Control Room.
If necessary, re-adjust the monitoring level by
rotating the [CONTROL ROOM LEVEL] control or the
[C-R PHONES] control.
INPUT
METER
STEREO BUS L
STEREO BUS R
INPUT
METER
PRE POST
INPUT A
INPUT CHANNEL
PAN
CHANNEL
FADER
INPUT B
POST