Yamaha pdm-4210 user manual Operating Instructions Displaying Multi Picture, Pictures Split

(Sub- screen)

OPERATING INSTRUCTIONS (continued)

Displaying MULTI PICTURE

RECALL button

VOL

PinP button

RGB 1 RGB 2 MUTE VOL

RECALL button

AV1 AV2 AV3 AV4

AUTO PinP SIZE RECALL

MENU

OK

RETURN button

ID ID SET

2 Pictures (Split)

If the PinP button on the remote control is pressed MULTI PICTURE will display.

Activating the P-in-P mode from the RGB input screen

Pressing the PinP button once will display 2 pictures.

•This mode can be available from RGB1(DVI-PC) and RGB2(RGB) input.

•The speaker icon can be shifted left and right by pressing the and SELECT buttons; the audio of the video will be output from

the side on which the speaker icon is located.

• The sub-screen position can be	RGB2
selected up and down by pressing
	AV1
SELECT buttons.

•When the speaker icon appears on the left of the subscreen, as in the illustration at right, you can use the

AV1, AV2, AV3, or AV4 buttons to select the subscreen input mode.

•Pressing the PinP button or the

RETURN button will cancel the 2 pictures display.

•"Frequency Mode" in the Setup Menu should be set to Movie when sub-screen is the component signal of 1080i/50 or 1080i/60.

AV1: Displays the VIDEO input signal of the sub-screen.

Activating the Split mode from the video input screen

Pressing the PinP button one time will display 2 pictures.

•The speaker icon can be shifted left

and right by pressing the and	AV1	AV2
SELECT buttons; the audio of the
video will be output from the side on
which the speaker icon is located.

•The same video input mode cannot be selected for both screens at the same time.

•Pressing the PinP button or the

RETURN button will cancel the 2 pictures display.

•When the Video input is set to RGB Video, this Split mode is not possible.

•Refer to the table for 2 pictures (Split) mode.

ENGLISH

Input terminal		AV1～AV4				AV1, AV2			RGB1	RGB2
	Sub	PAL-N	NTSC-M 576i 480i			1080i/50	1080i/60 720p/60		STB	Component
	Main		PAL-M	576p	480p						Sub
AV1	PAL-N	○	○	○	○	○	○	○		Main
～AV4	NTSC-M , PAL-M	○	○	○	○	○	○	○
	576i, 576p	○	○
AV1	480i, 480p	○	○
	1080i/50	○	○
AV2
	1080i/60	○	○
	720p/60	○	○
RGB1	STB
RGB2	Component	○	○	○	○	○	○	○
									(○ : Available)
NOTE

•Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not change to power save mode.

•Please be careful since image retention will occur if the plasma monitor is left in MULTI PICTURE display state for a long period of time.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.

•The display will go out in approximately 6 seconds.

VIDEO

Off-timer On-timer

OFF -- -- Min.

-- -- : -- --

AV1 Input mode

Composite Signal mode

35