Yamaha RX-397 owner manual Playing and Recording, Playing a source, Front panel

PLAYING AND RECORDING

CAUTION

Extreme caution should be exercised when you play back CDs encoded in DTS.

If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS.

Playing a source

FM/AM	l TUNING h
	PURE DIRECT	TAPE MONITOR
EDIT	MEMORY TUNING MODE

										16
									20	12
A/B/C/D/E	1	2	3	4	5	6	7	8	VOLUME
									26	8
INPUT		BASS		TREBLE		BALANCE		LOUDNESS
PHONES	SPEAKERS								40	4
STANDBY									60	2
/ON

∞0

-dB

5 1 2 4

	SLEEP			POWER
1	CD/DVD	PHONO	TUNER	STANDBY
	MD	TAPE	AUX	A
				SPEAKERS	2
				B
	u		+		4
	d		–
	PRESET		VOLUME

A/B/C/D/E

MUTE

1Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the desired input source.

INPUT

	SLEEP	POWER
or	CD/DVD PHONO TUNER	STANDBY
	MD TAPE AUX	SPEAKERS
		A
		B
Front panel	Remote control

Note

You cannot select any input source while the TAPE MON indicator lights up in the front panel display.

2Press SPEAKERS A and/or SPEAKERS B on the front panel or on the remote control to select speakers A and/or speakers B.

SPEAKERS		SPEAKERS
A	B	A
		or
		B
Front panel		Remote control

Notes

•Both SPEAKERS A and B can be selected.

•Make sure that the IMPEDANCE SELECTOR switch is correctly set (see page 13).

3Play the source.

4Rotate VOLUME on the front panel (or press VOLUME +/– on the remote control) to adjust the sound output level.

	16
20	12
VOLUME
26	8		+
40	4	or	VOLUME
60	2		–
∞	0
	-dB
Front panel			Remote control

5Press STANDBY/ON on the front panel again (or press STANDBY on the remote control) to finish using this unit and set it to the standby mode.

STANDBY

/ON	or
STANDBY

OPERATION

Front panel Remote control

15