Yamaha RX-V1600 owner manual Using RE-NAME

REMOTE CONTROL FEATURES

Using RE-NAME

You can change the name of the input source that appears in the display window on the remote control if you want to use a different name than the factory preset. This is useful when you have set the input selector to control a different component.

1Set AMP/SOURCE/TV to AMP or SOURCE.

AMP

SOURCE

TV

2Press an input selector button to select the source component you want to rename.

The selected component name appears in the display window.

A	XM	AUDIO SEL	SLEEP
PHONO	TUNER	CD	MULTI CH IN
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

5Press l / h to move the cursor to the next position.

PRESET/CH

ENTER

A-E/CAT

6Press ENTER to set the new name.

OK appears in the display window if renaming was successful.

NG appears in the display window if renaming was unsuccessful. In this case, start over from step 4.

y

If you continuously want to rename another component, press the input selector button or SELECT k / n to select the component, then repeat steps 4 through 6.

7Press RE-NAME again to exit the renaming mode.

RE-NAME

(U.S.A. model)

3Press RE-NAME using a ballpoint pen or similar object.

RE-NAME

Note

If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, press RE-NAME again.

4Press k / n to select and enter a character.

Pressing n changes the character as follows:

A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),

/ (slash), and space.

(Pressing k changes the characters in reverse order.)

PRESET/CH

ENTER

A-E/CAT.

Note

ERROR appears in the display window if you press a button not indicated in the respective step, or when you press more than one button simultaneously.

98