Yamaha RX-V1600 owner manual Using Option Menu, Adisplay SET

Using OPTION MENU

Use to manually adjust the optional system settings.

4 OPTION MENU 1/2		4 OPTION MENU 2/2
. A)DISPLAY		. E)PARAM. INI
B)MEMORY GUARD		F)ZONE SET
C)AUDIO SELECT		G)XM RADIO SET
D)DECODER MODE
p	p	p	p

■Display set A)DISPLAY SET

Use this feature to adjust the display settings.

Note

The parameter settings for DISPLAY SET (except for the DIMMER setting) can be initialized to the factory presets. Use the V-RESET feature in the ADVANCED SETUP menu (see page 91).

A)DISPLAY SET

. DIMMER;;;;;;;0 OSD SHIFT;;;;0

GRAY BACK;AUTO V CONV.;;;;;ON

p p

Dimmer DIMMER

Use to adjust the brightness of the front panel display. Choices: –4 to 0

OSD shift OSD SHIFT

Use to adjust the vertical position of the OSD. Choices: +5 (downward) to –5 (upward) Initial setting: 0

•Press h to lower the position of the OSD.

•Press l to raise the position of the OSD.

Gray back GRAY BACK

Choices: AUTO, OFF

•Select AUTO to display a gray background in the OSD when there is no video signal being input.

•Select OFF not to display a gray background even when there is no video signal being input.

MANUAL SETUP

Video conversion V CONV.

Use this feature to activate or deactivate the component interlace/progressive conversion as well as the HDMI interlace/progressive up-conversion of the analog video signals input at the composite video, S-video and component video jacks.

Choices: ON, OFF

•Select ON to activate the component interlace/ progressive conversion as well as the HDMI interlace/ progressive up-conversion of the analog video signals.

•Select OFF to deactivate the component interlace/ progressive conversion as well as the HDMI interlace/ progressive up-conversion of the analog video signals.

y

When using the THX system, we recommend setting V CONV. to OFF.

Notes

•The OSD is not displayed when V CONV. is set to OFF.

•Even when V CONV. is set to ON, HDMI digital signals are not converted to analog video signals.

•If V CONV. is set to OFF, the CMPNT I/P and HDMI I/P features are deactivated.

•Converted video signals are only output at the MONITOR OUT jacks. When recording you must make the same type of video connections (composite or S-video) between each component.

•When converting composite video or S-video signals from a VCR to component video signals, the picture quality may suffer depending on your VCR.

•Unconventional signals input at the composite video, S-video or component video jacks cannot be converted even if V CONV. is set to ON.

•If unconventional signals are being input at the composite video, S-video or component video jacks, the video output may be abnormal as a result. In such cases, set V CONV. to OFF.

Component interlace/progressive conversion

CMPNT I/P

Use this feature to activate or deactivate the analog I/P conversion of the analog video signals input at the composite video, S-video and component video jacks so that the analog video signals deinterlaced from 480i to 480p are output at the MONITOR OUT jacks.

Choices: ON, OFF

•Select ON to activate the analog I/P conversion of the analog video signals.

•Select OFF to deactivate the analog I/P conversion of the analog video signals.

Notes

•This menu item is not available and hence not visible in the OSD if V CONV. is set to OFF.

•If your video monitor does not support the analog video signals with 480p of resolution, the SET MENU items may not be displayed on your video monitor when CMPNT I/P is set to ON.

OPERATION ADVANCED

85