Yamaha RX-V1600 owner manual Advanced Operations, Selecting the OSD mode Adjusting speaker levels

ADVANCED OPERATIONS

You can switch between the available OSD modes and manually adjust the output level of each speaker.

Selecting the OSD mode Adjusting speaker levels

You can display the operating information of this unit on a video monitor. If you display the SET MENU and sound field program parameter settings on a monitor, it is much easier to see the available options and parameters than it is to read the information in the front panel display.

Turn on the video monitor connected to this unit and then press ON SCREEN on the remote control repeatedly to change the OSD mode.

The OSD mode changes in the following order: Full display → Short display → Display off

Full display

ON SCREEN

You can manually adjust the output level of each speaker while listening to a music source. This is also possible when playing sources through the MULTI CH INPUT jacks.

Note

This operation will override the level adjustments made in AUTO SETUP (see page 32) and SP LEVEL (see page 80).

	+	+	+	AMP	1
	TV VOL	CH	VOLUME	SOURCE
	–	–	–	TV
	TV MUTE	TV INPUT	MUTE
2	LEVEL	PRESET/CH	SET MENU PURE DIRECT
	TITLE		MENU
	BAND		SRCH MODE	NIGHT
					3
		ENTER		AUDIO
	A-E/CAT.

DISPLAY

Full display

Short display

Display off

	ON SCREEN STRAIGHT
RETURN	DISPLAY
XM MEMORY	EFFECT

(U.S.A. model)

1Set AMP/SOURCE/TV to AMP.

Fully shows the sound field program parameter settings as well as the contents of the front panel display.

Short display

Briefly shows the contents of the front panel display at the bottom of the screen each time you operate this unit.

Display off

Only the operations performed using ON SCREEN on the remote control are displayed. However, the OSD is displayed when using SET MENU or the test tone feature even if the OSD mode is turned off.

MUSIC

. Pop/Rock

DSP LEVEL ; ; ; ; 0dB

P . INIT . DLY ; ; 21ms

P . ROOM SIZE ; ; 1 . 0

S . INIT . DLY ; ; 31ms

S . ROOM SIZE ; ; 1 . 0

	MUSIC
	Pop/Rock
Full display	Short display

Notes

•The OSD signal is not output at the OUT (REC) jack and will not be recorded.

•You can display a gray background in the OSD when there is no video signal being input by setting GRAY BACK to AUTO (see page 85).

•The OSD is not displayed in the following cases:

–When video signals in the progressive format or HDTV video signals are being input.

–When the signals input at the HDMI IN 1 or HDMI IN 2 jack are being output at the HDMI OUT jack.

–When V CONV. is set to OFF (see page 85).

AMP

SOURCE

TV

2Press LEVEL repeatedly to select the speaker you want to adjust.

LEVEL

TITLE

BAND

FRONT L adjusts the front left speaker level. CENTER adjusts the center speaker level. FRONT R adjusts the front right speaker level. SUR.R adjusts the surround right speaker level. SB R adjusts the surround back right speaker level. SB L adjusts the surround back left speaker level. SUR.L adjusts the surround left speaker level. SWFR adjusts the subwoofer level.

PRNS L adjusts the presence left speaker level. PRNS R adjusts the presence right speaker level.

3Press l / h to adjust the speaker output level.

Control range: +10 dB to –10 dB

OPERATION ADVANCED

89