CONNECTING SPEAKERS

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut to be as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass.

Do not let the bare speaker wires touch each other and do not let them touch the metal parts of this unit as this could damage this unit and/or speakers.

●Use speakers with the specified impedance shown on the rear of this unit.

How to Connect:

Front speaker connection:

One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either the FRONT A or B terminals.

Rear speaker connection:

One rear speaker system can be connected to the REAR terminals.

Center speaker connection:

One or two center speakers can be connected to this unit. If you connect only one center speaker, connect it to either the CENTER C or D terminals.

Red: positive (+)

Black: negative (–)

2

1

➀Unscrew the knob.

➁Insert the bare wire.

3

[Remove approx. 5mm

 

(1/4") insulation from

the speaker wires.]

➂Tighten the knob and secure the wire.

While connecting, be sure to set the CENTER speaker impedance switch to the proper position.

Set to “C + D” when using two center speakers, or to “C OR D” when using only one center speaker. If the switch is set to the improper position, no sound may be heard from the center speaker.

CD

C OR D

*Banana Plug connections are also possible. Simply insert the Banana Plug connector into the corresponding terminal.

USING AUX TERMINALS (ON THE FRONT PANEL) <for RX-V1070 only>

These terminals are used to connect an auxiliary video input source such as a camcorder to this unit.

AUDIO OUT

R

AUDIO OUT

L

VIDEO OUT

VIDEO

Camcorder

9