Yamaha RX-V2095 mIMPEDANCE SELECTOR switch, IMPEDANCE SELECTOR, Note on a subwoofer connection:, Note on main speaker connections:

PREPARATION

Note on main speaker connections:

One or two speaker systems can be connected to this unit. If you use only one speaker system, connect it to either the SPEAKERS A or B terminals.

Note on a subwoofer connection:

You may wish to add a subwoofer to reinforce low frequencies or to output low bass sound from the subwoofer channel when reproducing discrete signals.

When using a subwoofer, connect the SUBWOOFER terminal of this unit to the INPUT terminal of the subwoofer amplifier, and connect the speaker terminals of the subwoofer amplifier to the subwoofer.

With some subwoofers, including the Yamaha Active Servo Processing Subwoofer System, the amplifier and subwoofer are in the same unit. Such a subwoofer needs only the connection between the SUBWOOFER terminal of this unit and the INPUT terminal of the subwoofer.

(Refer to page 24 for details about the SUBWOOFER terminal.)

English

mIMPEDANCE SELECTOR switch

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.

IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED:

The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit is in the standby mode.

(U.S.A. model)

REAR

AC OUTLETS

SWITCHED

I20V

80Hz

I00W

(SURROUND)MAX.

TOTAL

IMPEDANCE SELECTOR

MAIN	A	SET BEFORE POWER ON
		CENTER	: 4ΩMIN. / SPEAKER
		FRONT	: 6ΩMIN. / SPEAKER
		REAR	: 4ΩMIN. / SPEAKER
		MAIN A OR B: 4ΩMIN. / SPEAKER
		A	B : 8ΩMIN. / SPEAKER
	B	CENTER	: 8ΩMIN. / SPEAKER
		FRONT	: 8ΩMIN. / SPEAKER
		REAR	: 8ΩMIN. / SPEAKER
		MAIN A OR B: 8ΩMIN. / SPEAKER
		A	B : I6ΩMIN. / SPEAKER

IMPEDANCE SELECTOR

Select the position whose requirements your speaker system meets.

(Upper position)

Center: The impedance of the speaker must be 4Ω or higher.

Rear: The impedance of each speaker must be 4Ω or higher.

Main: If you use one pair of main speakers, the impedance of each speaker must be 4Ω or higher.

If you use two pairs of main speakers, the impedance of each speaker must be 8Ω or higher.

Front effect:

The impedance of each speaker must be 6Ω or higher.

(Lower position)

Center: The impedance of the speaker must be 8Ω or higher.

Rear: The impedance of each speaker must be 8Ω or higher.

Main: <Except Canada model>

If you use one pair of main speakers, the impedance of each speaker must be 8Ω or higher.

If you use two pairs of main speakers, the impedance of each speaker must be 16Ω or higher.

<For Canada model only>

The impedance of each speaker must be 8Ω or higher.

Front effect:

The impedance of each speaker must be 8Ω or higher.

23