Yamaha RX-V2095 How to Connect:, Speakers

PREPARATION

Speakers

Use speakers with the specified impedance shown on the rear of this unit.

Front effect speakers Rear speakers

RightLeft

RightLeft

Center speaker

Subwoofer system

					SPEAKERS
			CENTER		FRONT	REAR
						(SURROUND)
		IN	OUT	CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
		REMOTE					IMPEDANCE SELECTOR
		CONTROL		A	MAIN	A
							SET BEFORE POWER ON
							CENTER	: 4ΩMIN. / SPEAKER
COUPLER			OUTPUT				FRONT	: 6ΩMIN. / SPEAKER
							REAR	: 4ΩMIN. / SPEAKER
MAIN		CENTER FRONT REAR					MAIN A OR B: 4ΩMIN. / SPEAKER
PRE	MAIN		(SURROUND)				A	B : 8ΩMIN. / SPEAKER
OUT	IN					B	CENTER	: 8ΩMIN. / SPEAKER
				B
							FRONT	: 8ΩMIN. / SPEAKER
							REAR	: 8ΩMIN. / SPEAKER
							MAIN A OR B: 8ΩMIN. / SPEAKER
							A	B : I6ΩMIN. / SPEAKER

SUB

WOOFER

Right Left Right Left

Main speakers B Main speakers A

How to Connect:

Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the speakers, or both.

Red: positive (+)

Black: negative (–)

2

1

3

<U.S.A., Canada, China, Australia and General models only>

Banana Plug connections are also possible. Simply insert the

Banana Plug connector into the corresponding terminal.

➀Loosen the knob.

➁Insert the bare wire.

[Remove approx. 5mm (1/4”) insulation from the speaker wires.]

➂Tighten the knob and secure the wire.

22