TROUBLESHOOTING
■Remote controlProblem | Cause | Remedy | Refer to | |
page | ||||
|
|
| ||
|
|
|
| |
The remote control | Wrong distance or angle. | The remote control will function within a | 8 | |
does not work nor |
| maximum range of 6 m (20 feet) and no more |
| |
function properly. |
| than 30 degrees |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition the unit. | — | |
| inverter type of fluorescent lamp, etc.) is |
|
| |
| striking the remote control sensor of this |
|
| |
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries with new ones. | 3 | |
|
|
|
| |
The unit or other | The component to be controlled has not been | Set the selector dial to the appropriate position, | 44 | |
component cannot be | selected. | corresponding to the component to be |
| |
controlled. |
| controlled. |
| |
|
|
|
| |
| The remote control cannot control system |
| — | |
| components. |
|
| |
| The manufacturer code has not been set up | Enter the code again. | 49 | |
| properly. |
|
| |
| Try setting another code for the same |
| ||
|
|
| ||
|
| manufacturer. |
| |
|
|
|
| |
| Depending on the manufacturer or the | Use the original remote control supplied with | — | |
| model, some components cannot be | your component. |
| |
| controlled with this unit’s remote control |
|
| |
| even though the code has been set up |
|
| |
| properly. |
|
| |
|
|
|
|
After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode, disconnect the power cord, plug it back in after 30 seconds, and start operating.
English APPENDIX
63