ABOUT THE ACCESSORY TERMINALS
OUTPUT
LOW | CENTER | REAR OUT |
PASS | OUT |
|
1
3
fo:200Hz
2
1LOW PASS terminal
This terminal is for output to a monaural amplifier driving a subwoofer. Frequencies above 200Ê Hz are filtered out so that only the bass range remains.
The output signal is from the front and center channels.
You may wish to add a subwoofer to reinforce the bass frequencies.
Connect the LOW PASS terminal to the INPUT terminal of the subwoofer amplifier, and connect the speaker terminals of the subwoofer amplifier to the subwoofer.
With some subwoofers, including the Yamaha Active Servo Processing Subwoofer System, the amplifier and subwoofer are in the same unit.
2CENTER OUTPUT terminal
This terminal is for center channel line output. There is no connection to this terminal when you use the
However, if you drive a center speaker with an external power amplifier, connect the input terminal of the external amplifier to this terminal.
3REAR OUTPUT terminals
These terminals are for rear channel line output. There is no connection to these terminals when you use the
However, if you drive rear speakers with an external stereo power amplifier, connect the input terminals of the external amplifier (MAIN IN or AUX terminals of a power amplifier or an inte- grated amplifier) to these terminals.
GND terminal (For turntable use)
GND
Connecting the ground wire of the turn- table to this terminal will normally minimize hum. In some cases, better results may be obtained with the ground wire disconnected.
AC OUTLETS | SWITCHED | UNSWITCHED | ||
| ||||
2 SWITCHED OUTLETS and 1 |
|
|
|
|
UNSWITCHED OUTLET (USA, |
|
|
|
|
Canada, and General models) |
|
|
|
|
1 SWITCHED OUTLET | 120V | 60Hz | 120V | 60Hz |
(Australa model) | 120W MAX. TOTAL | 200W MAX. | ||
| (USA model) | |||
2 SWITCHED OUTLETS |
| |||
(Singapore model) |
|
|
|
|
Use these to connect the power cords from your components to this unit.
The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. These outlets will
supply power to any connected component whenever this unit is turned on.
The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 120 watts.
The power to the UNSWITCHED outlets cannot be controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. (USA, Canada, and General models only).
The maximum power (power consumption of compo- nent) that can be connected to the UNSWITCHED AC OUTLET is 200 watts (USA model), 180 watts (Canada model) and 200 watts (General model).
11