CASSETTE OPERATIONS

Although the RX21 has a considerable amount of internal storage capacity, a cassette interface has been provided to facilitate storage on a standard cassette tape of an unlimited number of your original patterns and songs. The RX21 cassette save and load operations let you save (store onto tape) and load (transfer from tape to RX21 memory) the entire RX21 memory contents at once-all patterns and songs (except the preset patterns, which are permanently stored in the RX21’s memory). Remember that when you perform a load operation the entire RX21 pattern and song memory is rewritten, erasing any data it might contain (excepting, again, the preset patterns). We recommend that you use a cassette player designed specifically for personal computer data storage. If such a cassette deck is not available, however, use the highest quality unit at your disposal.

If loading problems are encountered, try adjusting the level control of the cassette player for optimum results. If your cassette player has tone controls, these may need to be adjusted as well to facilitate loading of the data. In some cases it may also be necessary to clean and demagnetize the cassette deck’s reproduction heads. Before you begin a cassette operation, check that your cassette recorder is properly connected to the RX21 8- pin DIN CASSETTE IN/OUT terminal (see “CONNECTIONS” diagram).

The SAVE and VERIFY buttons permit access to two functions: 1) SAVE actually

Save/Verify stores the data in the RX21 memory onto cassette tape, and 2) VERIFY automatically compares the data written onto the cassette with that in the RX21 memory in order to confirm that the data has been properly saved.

To begin any cassette operation, first enter the cassette control mode by pressing the CASSETTE button. The LCD will read "CASSETTE CONTROL" indicating that the cassette control mode is active. The three buttons below the CASSETTE button now function according to the name written ABOVE them, rather than the name written ON them. In other words:

REPEAT KEY becomes SAVE KEY

INSERT KEY becomes LOAD KEY

DELETE KEY becomes VERIFY KEY

To save the RX21 memory contents, first start the cassette recorder running in the record mode. Once the recorder is running, press the SAVE button. The LCD will read "SAVE EXECUTING", indicating that the data is being saved. This operation will take about 12 seconds. The LCD will then show "SAVE COMPLETED" for about 2 seconds, followed by "CASSETTE CONTROL".

To verify that the save operation was successful, stop the cassette recorder, and rewind it to the beginning of the file just saved (it’s good to zero the tape counter on your cassette recorder prior to recording, so you can now simply rewind to the zero point. Also, once you’ve done a save operation, you’ll know the characteristic high-pitched sound of saved data, and be able to rewind to the start of the data using a review control, if your recorder has one). Press the VERIFY button, and start the recorder in the playback mode. The RX21 will then compare the contents of its memory to the data saved on the tape, an operation lasting about 12 seconds.

The LCD panel will read “VERIFY EXECUTING". If no data errors are encountered, the LCD panel will read “VERIFY OK”, followed by "CASSETTE CONTROL". The cassette recorder can be stopped at this point.

If an error is encountered, the display will read “VERIFY ERROR". If this happens, the RX21 will not function for about 2 seconds. You can then return to the cassette control mode by pressing the CASSETTE button and try saving the data again.

If you wish to stop an operation before the RX21 has completed a function, press

34