88
3-2-13: CONTROL LFO
All of the modulation-type effects — chorus, flanging, etc. — require LFO con-
trol. The TG500 has an independent effect LFO that is set up by the following pa-
rameters.
PERFORMANCE EDIT MODE / 3: Full Edit. 3-2: Effect
3-2-13: CONTROL LFO
Wave (LFO waveform)
Range: tri, dwn, up, squ, sin, S/H, 1tm
Determines the waveform of the effect LFO.
“tri” = Triangle. “dwn” = Downward sawtooth.
“up” = Upward sawtooth. “squ” = Square.
“sin” = Sine. “S/H” = Sample and hold.
“1tm” = Upward 1-shot.
Speed (LFO speed)
Range: 0 … 99
Sets the speed of the effect LFO.
“0” is the slowest speed setting, producing an LFO speed of approximately
0 Hertz. The fastest setting of 99 produces an LFO speed of approximately 25
Hertz.

Delay

Range: 0 … 99
Sets the delay time between the beginning of a note and the beginning of
effect LFO operation for the selected element.
The minimum setting “0” results in no delay, while the maximum setting of
“99” produces a delay of approximately 2.66 seconds before the LFO begins
operation (5.3 seconds before it reaches maximum depth).

∆≈∆

Delay
Speed
Wave
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-2:Effect -> [ENTER]
-> [PAGE] -> 3-2-13 :Control LFO -> [ENTER]