Yamaha TG500 3-1-08: VELOCITY LIMIT-L / 3-1-09: VELOCITY LIMIT-H

69
3-1-08: VELOCITY LIMIT-L / 3-1-09: VELOCITY LIMIT-H
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
3-1-08: VELOCITY LIMIT-L / 3-1-09: VELOCITY LIMIT-H
The high and low velocity limit parameters make it possible to produce a range of
“velocity switching” effects in which different layers of a performance combination
are set up to produce sound only when the keyboard is played at a certain velocity.
You could, for example, produce a flute sound by playing softly, and a horn sound
by playing harder.
VelLmt-L (layer A)
VelLmt-H (layer A)
The layer to be edited can be selected as described on page 50. The currently
selected layer is shown in square brackets on the upper display line.
VelLmt-L (Low velocity limit)
Range: 1 … 127
Sets the lowest velocity value for a range of velocity values over which
each active layer will produce output.
Use the [ ] and [ ] keys (or the standard layer selection procedure) to select
the layer to be edited, then use the [-1/NO] and [+1/YES] keys to set the low
velocity limit of the voice assigned to that layer.
Every note played on a keyboard or other MIDI controller produces a
“velocity” value that tells the tone generator how hard the note has been
played. The range of MIDI velocity values is from 1 to 127 — thus the 1 ...
127 range of this parameter.
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-08 : Vel Limit-L -> [ENTER] 3-1-09 : Vel Limit-H ->
[ENTER]