PERIODIC MAINTENANCE AND MINOR REPAIR

To change the engine oil and clean the oil strainer

1

ZAUM00**

1.Oil filler cap

1.Start the engine, warm it up for sev- eral minutes, and then turn it off.

2.Place an oil pan under the engine to collect the used oil.

3.Remove panel A. (See page 6-6.)

4.Remove the engine oil filler cap and drain bolts to drain the oil from the crankcase.

1

ZAUM00**

1. Drain bolt A

ECA10410

cC

When removing the engine oil drain bolt, the O-ring, spring, and oil strainer will fall out.Take care not to lose these parts.

5.Clean the oil strainer with solvent, and then check it for damage and replace it if necessary.

4 3 2 1

1

ZAUM00**

1.

Drain bolt B

2.

O-ring

3.

Spring

4.

Strainer

6.Check the O-ring for damage and re-

6

place it if necessary.

 

7.Install the oil strainer, spring, O-ring and engine oil drain bolts, and then tighten the drain bolts to the speci- fied torque.

Tightening torque: Engine oil drain bolt A:

23 Nm (2.3m • kgf, 16.6ft • lbf) Engine oil drain bolt B:

32 Nm (3.2m • kgf, 23.1ft • lbf)

6-25