Setting Up

Be sure to do the following operations BEFORE turning on the power.

Power Requirements

Make sure that the [STANDBY/ON] switch of the instrument is set to STANDBY.

WARNING

•Use ONLY a Yamaha PA-5D AC Power Adaptor (or other adap- tor specifically recommended by Yamaha) to power your instrument from the AC mains. The use of other adaptors may result in irreparable damage to both the adaptor and the instrument.

Connect the AC adaptor (PA-5D or other adaptor specifically recommended by Yamaha) to the power supply jack.

Plug the AC adaptor into an AC outlet.

CAUTION

•Unplug the AC Power Adaptor when not using the instrument, or during electrical storms.



 



PA-5D

AC outlet

10 DGX-620/520, YPG-625/525 Owner’s Manual

Make all necessary connections below BEFORE turning the power on.

Connecting Headphones (PHONES/OUTPUT Jack)

The instrument speakers are automatically shut off when a plug is inserted into this jack. The PHONES/ OUTPUT jack also functions as an external output. You can connect the PHONES/OUTPUT jack to a keyboard amplifier, stereo system, mixer, tape recorder, or other line-level audio device to send the instrument’s output signal to that device.

WARNING

•Avoid listening with the headphones at high volume for long peri- ods of time; doing so may not only result in ear fatigue, it may be damaging to your hearing.

CAUTION

•To prevent damage to the speakers, set the volume of the external devices at the minimum setting before connecting them. Failure to observe these cautions may result in electric shock or equipment damage. Also, be sure to set the volumes of all devices at their minimum levels and gradually raise the volume controls while playing the instrument to set the desired listening level.

Connecting a Footswitch (SUSTAIN Jack)

The sustain function lets you produce a natural sustain as you play by pressing a footswitch. Plug the Yamaha FC5 footswitch into this jack and use it to switch sustain on and off.

NOTE

•Make sure that the footswitch plug is properly connected to the SUS- TAIN jack before turning on the power.

•Do not press the footswitch while turning the power on. Doing this changes the recognized polarity of the footswitch, resulting in reversed footswitch operation.