Keyboard Stand Assembly

CAUTION

Read these cautions carefully before you assemble or use the keyboard stand.

These cautions are to promote safe use of the stand and to prevent injury and damage from occurring to you and others. By following these cautions carefully, your keyboard stand will provide you with safe and prolonged use.

•Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below.

•Assembly should be carried out by at least two persons.

•Be sure to use the correct screw size, as indicated above. Use of incorrect screws can cause damage.

•Use the stand after assembly is complete. An uncompleted stand may overturn or the keyboard may drop.

•Always place the stand on a flat, stable surface. Placing the stand on uneven surfaces may cause it to become unstable or overturn, the keyboard to drop, or injury.

•Do not use the stand for anything other than its designed purpose. Placing other objects on the stand may result in the object dropping or the stand overturning.

•Do not apply excessive force to the keyboard as it may cause the stand to overturn or the keyboard to drop.

•Make sure the stand is sturdy and safe, and all screws have been tight and firm before use. If not, the stand may overturn, the keyboard may drop, or may result in injury to the user.

•To disassemble, reverse the assembly sequence given below.

Have a phillips-head (+) screwdriver ready.

The parts shown in the “Assembly Parts” illustration will be used. Follow the assembly instructions and select the parts as needed.

Assembly Parts

Back board

Side boards

Stand bases

(DGX-620/YPG-625 only)

(DGX-620/YPG-625 only)

q 6 x 70 mm roundhead screws (4 pcs.)

w Joint connectors (4 pcs.)

e 6 x 30 mm roundhead screws (4 pcs.)

r 5 x 16 mm roundhead screws (4 pcs.)

t Support rail

y 4 x 45 mm flathead screws (6 pcs.)

1

w Joint connectors

q 6 x 70 mm roundhead screws

z Attach the stand bases.

Making sure that the boards are facing the proper direction (the holes should face inside). The left and right side boards for the DGX-520 and YPG-525 are the same shape. Insert the joint connectors w into the holes as shown. The joint connectors have been installed properly if you can see a plus mark on the connector.

Attach the stand bases to the rear of the side boards, using the 6 x 70 mm roundhead screws q. The left and right stand bases are the same shape, and there is no difference between their front-to-back orientation. If you have trouble screwing in the screws, use a screwdriver to rotate the joint connectors to the appropriate position—the → mark on the joint connectors indicates the location of the screw hole.

116 DGX-620/520, YPG-625/525 Owner’s Manual