46
YPP-200
1
CAUTION
• Be careful not to confuse parts, and be sure to install all parts
in the correct direction. Please assemble in accordance with
the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above.
Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of
each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
The parts shown in the “Assembly Parts”
illustration will be used. Follow the assembly
instructions and select the parts as needed.
ZAttach the stand bases.
Making sure that the boards are facing the proper
direction (the holes should face inside), insert the joint
connectors 2 into the holes as shown. The joint
connectors have been installed properly if you can see a
plus mark on the connector.
Attach the stand bases to the rear of the side boards,
using the 6 x 70 mm round head screws 1.
Keyboard Stand Assembly
16 x 70 mm round head screws (4 pcs.)
2Joint connectors (4 pcs.)
33.5 x 16 mm tapping screws (12 pcs.)

Assembly Parts

Back board
Side boards
Stand bases
2Joint connectors
16 x 70 mm round head screws
46 x 30 mm round head screws (4 pcs.)
55 x 16 mm round head screws (4 pcs.)
6Angle brackets (4 pcs.)