AUTO SETUP

3Press MENU on the remote control.

The SET MENU screen appears on your TV.

SET MENU

MENU

.;MEMORY

;AUTO SETUP

;BASIC SETUP

;MANUAL SETUP

[]/[]:Up/Down

[ENTER]:Enter

5Press / to select BEAM OPT+SOUND OPTIMZ, BEAM OPTIMZ only or SOUND OPTIMZ only and then press ENTER.

The following screen appears on your TV.

ENTER

ENTER

y

•The control buttons used for SET MENU are displayed on the bottom of the screen.

•To return to the previous screen while using SET MENU, press RETURN on the remote control.

•To resume cursor button operations after changing the control area by pressing an input selector button, press TEST on the remote control.

•To cancel the SET MENU screen, press MENU once more.

•You can also perform the following operations in the front panel display.

•If you press an input selector button during the SET MENU operations, the cursor buttons become ineffective. In this case, press TEST once.

4Press / on the remote control to select AUTO SETUP and then press ENTER.

The following screen appears on your TV.

ENTER

ENTER

;AUTO SETUP

.BEAM+SOUND OPTIMZ

BEAM OPTIMZ only

SOUND OPTIMZ only

[]/[]:Up/Down

[ENTER]:Enter

PREPARATION

.INSTALLING;;Parallel to Wall

MOUNTING;;;;SHELF

REFLECTING;;NORMAL

Set MIC in front of YSP

 MIN 2m/6.5ft

[]/[]:Up/Down/[p]/[p]:Sel

[ENTER]:Start

BEAM OPT+SOUND OPTIMZ

(Beam optimization and YPAO sound optimization)

Use to optimize the beam angle, delay, volume and quality so that the parameters best match your listening environment. It takes about three minutes.

It is recommended that you should select this optimization feature in the following cases:

•If you make settings for the first time.

•If the unit has been relocated.

•If your listening room has been restructured.

•If the objects in your listening room (furniture, etc.) have been rearranged.

BEAM OPTIMZ only (Beam optimization only)

Use to optimize the beam angle so that the parameter best matches your listening environment. It takes about a minute.

SOUND OPTIMZ only

(YPAO sound optimization only)

Use to optimize the beam delay, volume and quality so that the parameters best match your listening environment. It takes about two minutes.

It is recommended that you should select this optimization feature in the following cases:

•If you have opened or closed the curtains in your listening room before using this unit.

•If you have manually set the beam angle.

Note

You must optimize the beam angle in the BEAM OPTIMZ only procedure before starting the SOUND OPTIMZ only procedure.

32