E

4)Reinstall the filter element. Make sure the O-ring is in position in the cup. Insert the cup and O-ring into the fil- ter housing 6. Screw the ring nut onto the filter housing until the ring is lightly seated.

5)Tighten the ring nut approximately an additional 1/4 turn until ring nut is tight. Align one of the four larger ring nut tabs into the slot of the locking tab. Install the locking tab bolt and tighten.

6)Run the engine and check the filter and lines for leaks.

EMU00991

ADJUSTING IDLING SPEED

w

8Do not touch or remove electrical parts when starting or during operation.

8Keep hands, hair and clothes away from flywheel and other rotating parts while engine is running.

cC

This procedure must be performed while the outboard motor is in the water. A flushing attachment or test tank can be used.

4-16