•The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is recommended at the start of each mowing season. Check engine manual for correct plug type and gap specifications.
NOTE: Your rider engine is equipped with a resistor spark plug, When replacing plug, make sure to use resistor type.
Lubrication
See Figure 19 for an illustration of the lube points described below.
Lube
Lube
Lube
Lube |
Lube |
(before |
reassemby) |
Viewed from the bottom |
Figure 19: Lubrication Chart
Blade Assembly
•Lubricate blade assembly and deck spindle only while reassembling the blade either after sharpening or replacement.
Pivot Points
•Lubricate all pivot points with light oil at least once a season.
Steering Shaft and Gear
•Lubricate steering shaft and spline at least once a season with light oil.
•Lubricate teeth of the external steering gears with automotive
Linkage
•Lubricate all deck linkage and height adjustment linkage with a light oil.
Front Wheels
•Lubricate at least once a season with automotive
Engine
•Maintain the engine as recommended in the separate engine manual.
Cleaning Engine
•Promptly wipe off any fuel or oil spilled on the machine with clean cloth.
•Clean the underside of the blade housing after each mowing. Do not let clippings or debris accumulate around the blade which may cause rust on the deck.
•Using a brush or cloth, remove grass, chaff or debris from the finger guard on the engine daily to prevent overheating of the engine. Do not clean with a forceful spray of water since water contaminates the fuel system.
•Keep the governor linkage, springs and controls free of debris.
•If engine muffler is equipped with spark arrester screen, remove and clean the screen regularly. Replace if damaged or plugged with debris.Clean muffler area and remove any grass or other debris before operating the unit.
Fuel Filter
Your unit is equipped with a replaceable
18
