Step 21. Pinch belt together so that it is not in the | Step 22. Pivot the control arm back to its original |
pulley groove, and the lower pulley can be | position and reinstall the |
pushed towards the engine. | the slot. |
| Step 23. Check and make sure the belt is routed |
Lower Pulley | inside the pulley halves and the belt guard pin. |
| |
Half |
|
Belt |
|
Belt
Guard
Pin
Step 24. Replace large baffle. | Step 27. Replace the eight phillips head screws | ||||||
Step 25. Replace small baffle and three hex | that hold the large baffle in place. | ||||||
| |||||||
head screws holding it in place. | Step 28. Replace the rear wheels, rear wheel | ||||||
Step 26. Replace blade adapter and blade. See | gears and hub caps. The gears need to | ||||||
be put on in the right way for the self | |||||||
the Blade Removal, Sharpening and | |||||||
propelled mechanism to work. Check | |||||||
Replacement Section for proper | |||||||
the installation of the gear by spinning | |||||||
assembly. | |||||||
the wheel. It should spin freely in one | |||||||
|
|
|
|
|
| ||
| Small Baffle | direction but not the other. If the wheel | |||||
|
|
|
|
|
| spins freely in both directions, flip the | |
|
|
|
|
|
| gear over. | |
|
|
|
|
|
| Step 29. Tip mower back onto its wheels | |
|
|
|
| Blade Adapter | Step 30. Go through the neutral adjustment test | ||
|
|
|
| in Section 7 - OPERATION. | |||
|
|
|
|
|
| ||
Blade |
| ||||||
|
|
|
|
| Large Baffle |
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Hex Head Screw
23
