INSTALLATION
Standard electrical outlet
Modular telephone jack
groove
Long telephone line cord
Power cord
The instructions below are for both table and wall installation.
1Choose a spot near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.
2Install the handset battery.
(For an illustration of battery installation, see the BATTERIES section in this manual.)
•Remove the battery cover by pressing on the indentation and sliding downward.
•Plug the battery pack connector into the handset, and place the battery pack and wires into the compartment.
•Replace the battery cover by sliding it on its track up over the battery compartment until it snaps firmly into place.
3Connect the telephone line cord.
Make sure the plugs snap firmly into place. (If you are wall mounting the phone, use the short line cord, and press the excess cord into the groove on the bottom of the base.)
4Connect the power cord as shown above.
NOTE: Connect power to the base unit before placing the handset in the cradle.
3
AT&T 9340 book_1ATT | 3 | 11/3/98, 12:40 PM |
