ASSEMBLY INSTRUCTIONS
ASSEMBLING THE HANDLEBARS

Before you can operate the unit, you must adjust the handlebars.

1.When you unpack the unit, loosen the two knobs on the inside of the handlebars (Fig. 1).

2.With the unit upright, swing the handlebars up into the operating position.

NOTE: Take care not to pinch the switch wires when positioning the handlebars.

3. Tighten the knobs to secure the handlebars in place.

NOTE: Do not over-tighten the knobs.

Handlebar

Knobs

Swing Top

Handlebars

Upwards

Fig. 1

USING THE CORD RETAINER

There is an extension cord retainer to prevent the extension cord from disconnecting during use. The retainer hangs from the cord guide bar.

NOTE: Do not plug the extension cord into the power source receptacle until the cord is connected to the cord retainer and plugged into the unit.

To use the cord retainer:

1.Fold the extension cord in half, forming a tight loop near the receptacle.

2.Push the loop through the bottom hole in the retainer (Fig. 2).

3.Slide the loop over the retaining clip and pull down until the cord fits snugly (Fig. 2).

Fig. 2

NOTE: Use a UL-approved extension cord. A 100-foot, 14-gauge cord is recommended. A 50-foot, 16- gauge cord is acceptable.

Both the cord retainer and guide bar restrain the extension cord and keep it out of the way at all times, safely to the side of the operator.

The extension cord and retainer will slide on the guide bar as the unit is moved to the left and right. Connect your extension cord to the unit as shown in Figure 3.

Cord Will Slide

Side to Side

Cord

Guide Bar

Fig. 3

8