OPERATING INSTRUCTIONS
STARTING INSTRUCTIONS

WARNING: Avoid accidental starting. Make sure

you are in the starting position when using the snow thrower. To avoid serious injury, the operator and unit must be in a stable position while starting.

You must follow this sequence correctly to start the unit.

1.Make sure you have plugged in the unit.

2.Press in and hold the red starter button (Fig. 4).

3.While holding the starter button, lift and hold the bail.

NOTE: The unit will NOT start if you fail to press and hold the starter button until you lift the bail.

4. Hold the bail and begin operating the unit (Fig. 5).

STOPPING INSTRUCTIONS

1.Release your hand from the bail.

2.The starter button will pop out and the unit will stop.

Bail

Starter

Button

Overload

Protection

Switch

Fig. 4

Fig. 5

OVERLOAD PROTECTION SWITCH

This unit is equipped with an overload protection switch to protect the circuit (that the unit is plugged into) from short circuit overloads.

If the switch pops out:

1.Release the bail and allow the unit to stop and cool for a minute.

2.Press the overload switch to reset. Resume operation (Fig. 4).

If the switch pops again shortly after the first time:

1.Allow the unit to cool for 15 to 30 minutes.

2.After the unit has cooled, press the overload switch to reset. Resume operation.

If the switch does not stay in, or if it continues to pop out during operation, take the unit to an authorized service dealer for repair.

OPERATING THE UNIT

1.Start the unit according to the Starting Instructions. The depth and weight of the snow governs the forward speed.

2.Push the unit so that it rides on the wheels and scraper.

3.Make sure the power cord is attached to the cord retainer and rests on the guide bar. The power cord should trail to the side of the operator.

9