ASSEMBLY

Hose Trimming

Tools Required: Utility Knife

1.Carefully measure the length needed. Re- member that although the hose is flexible, it will not stretch.

2.Measure the same length on the hose that needs to be trimmed, and with the utility knife, cut through the webbing at the proper location.

3Continue that cut through the webbing all the way around the hose so that it finishes just across the support coil from where the original cut was started.

4.Use the utility knife to score the support coil between the beginning and end of the web cut. Set aside the knife, and finish breaking the coil by hand by working the scored portion back and forth until it breaks apart.

Door Tightness Adjustment

Tools Required:

1.9/16" Wrench

2.Ratchet

3.9/16" Socket

4.Clamps

Clevis Pin

Rod

End

Arm

Door

1.Remove arms from door by removing the 3/8” x 1-3/4” clevis pins.

2.Clamp door tightly shut.

3.Adjust arm length so that rod ends on arms can be fastened to the door.

4.Fasten arms to door.

5.If door is still too tight or too loose, repeat steps 1-4 and adjust the clamp tightness until door is at desired tightness.

10

Page 10
Image 10
Yazoo/Kees Z9A manual Hose Trimming